After verifying all files and that there is only one set; here is a note for your preparation: when changing versions of Phoenix, the way my flashing cable drivers get installed is this (and please note that i am only giving the required steps one by one - no jumping ahead or assuming):
1. Open Phoenix
2.
File menu >
Open Product3.
Flashing menu >
Firmware Update4.
Product Code menu >
... (select product code)
5. Remove battery from your phone and hold power for a few seconds, then connect the USB (and never use the main USB port) and insert the battery.
Now Windows should install the flashing cable drivers for your phone.
6. Let it finish (the icon in the system tray indicating new hardware will go away) and close Phoenix and disconnect your phone.
7. Open Phoenix and repeat the previous steps (with the battery out of phone and the phone is not to be connected) for the dead flash.
8. Go through with the flash (and i think
Refurbish would not be a bad call on this one) and connect the USB cable then insert the battery (and do NO MORE than that) when prompted by Phoenix. DO
NOT press anything on the phone.
9. Phoenix should be prepping the flash...
10. Click
OK and hold your breath